Skip to main content


To determine if internal engine damage is causing no start condition, perform the following steps: ‪

  1. Install a 3/4 in. breaker bar or ratchet and attempt to bar the engine over by hand.
  2. Determine severity of internal engine damage.
    1. If the engine rotates freely, check the electronic control module wiring harness; refer to section .
    2. If the engine binds and will not rotate freely, replace crankshaft bearings; refer to section and cylinder liners; refer to section .

Internal Engine Damage Replacement

Perform the following steps for crankshaft bearings, and cylinder liners replacement: ‪

  1. Replace the crankshaft bearings; refer to section .
  2. Replace the cylinder liners; refer to section .
  3. Verify replacement of components; refer to section .
Test Engine with Replaced Components

Perform the following steps to determine if the new components resolved no start condition: ‪

  1. Attempt to start and run the engine.
    1. If the engine starts and runs, no further troubleshooting is required. Shut down the engine.
    2. If the engine fails to start or run, call Detroit Diesel Technical Service.