Skip to main content

SERIES 60 IGNITER MODULE

The igniter module creates a ground path for the ignition coil primary circuit and limits the current to 7.5 amps. A 12-volt power source is supplied to the igniter module along with the command signals from the ECM. ‪

Removal of Igniter Module

Remove the igniter module as follows: ‪

  1. Disconnect the ignitor coil harness from the igniter module.
  2. Unscrew the two M6 x 1.0 attachment bolts.
  3. Inspect the igniter. Refer to section .
Inspection of Igniter Module

Inspect the igniter module as follows: ‪

  1. Visually check the back surface of the igniter module, igniter module bracket, and connectors for dirt and debris.

    EYE INJURY

    To avoid injury from flying debris when using compressed air, wear adequate eye protection (face shield or safety goggles) and do not exceed 40 psi (276 kPa) air pressure.

    1. If dirt and debris are present, clean as necessary with compressed air and reuse. Refer to section .
    2. If no dirt or debris are present, reuse the igniter module. Refer to section .

Installation of Igniter Module

Install the igniter module as follows: ‪

  1. Install the two M6 x 1.0 mounting screws. Torque to 13 - 16 Nm (10-12 lbft).
  2. Press the connectors into the igniter module.