The following are guidelines which may be used for splices. The methods described are not the only acceptable methods. Any method should produce a high quality, tight splice with durable insulation which can be expected to last the life of the vehicle.
The selection of crimpers and splice connectors is optional. Select a high quality crimper equivalent to Kent-Moore tool J 38706
and commercially available splice clips.
The following is a list of tools required for splicing wires:
Rosin core solder
Heat shrink tubing
To splice straight leads:
Locate broken wire
Remove insulation as required; ensure exposed wire is clean and not corroded.
Slide a sleeve of shrink wrap on the wire long enough to cover the splice and overlap the wire insulation, about 1/4 inch on both sides.
Insert one wire into splice clip (P/N: 0597428 or equivalent) and crimp.
Soldering splice connectors is optional. To solder splice connectors:
use rosin core solder.
Check the exposed wire before the splice is crimped in its connector. The exposed wire must
be clean before the splice is crimped.
Use a suitable electronic soldering iron to heat the wires. Apply the solder to the heated wire (not to the soldering iron), allowing sufficient solder flow into the splice joint.
Pull on connection to assure crimping and soldering integrity.
Shrink wrap is required. Alpha FIT-300, Raychem TAT-125 or any equivalent heat shrink, dual wall, epoxy encapsulating adhesive polyolefin is required. For information on this product contact the companies listed in Table
Alpha Wire Corporation
Raychem Corporation, Thermofit Division
711 Lidgerwood Ave.
300 Constitution Drive
P.O. Box 711
Elizabeth, New Jersey 07207-0711
Menlo Park, CA 94025
To heat shrink wrap a splice:
Select the correct diameter to allow a tight wrap when heated. The heat shrink wrap must
be long enough to overlap the wire insulation about 6.35 mm (0.25 in.) on both sides of the splice.
Heat the shrink wrap with a heat gun; do not concentrate the heat in one location, but play the heat over the entire length of shrink wrap until the joint is complete.